Polaris Trail Blazer Service Manual page 612

('99 & Early 2000 Sportsman 335, '99 Xplorer 300)
Hub Engagement Limiter RPM Test Procedure, cont.
6. Disconnect the remaining (neutral light) Green/White
wire from the Green/White terminal on the board and
connect it to the Brown/White terminal on the board.
7. Connect the Green/White wire disconnected in step 6 to
the Brown/White terminal on the terminal board.
8. Connect a tachometer
instructions.
9. Apply and lock the parking brake.
10. Start the engine. Be sure the machine is in neutral before
starting.
11. Place the All Wheel Drive (AWD) switch in the OFF
position (button out - no AWD).
12. Slowly increase RPM above 4000.
13. Push the AWD button to select All Wheel Drive. The
neutral light should light up, indicating an interrupted
ground path through the LR83 (power on the
Brown/White terminal is finding ground through the
neutral light bulb.
14. Slowly let RPM drop back to idle. The neutral light should
go out below approximately 4000 RPM, indicating a good
ground through the LR83 module. The neutral light
should not illuminate whenever AWD is selected below
4000 RPM.
WARNING: The procedures outlined above are for testing
purposes only. Return all wires to the proper terminal on the
terminal board (according to color) after testing. Verify proper
neutral light operation.
Polaris Sales Inc.
following manufacturer's
10.43
ELECTRICAL
All Wheel Drive System
99/00 ATV Update 12/99