Decal Replacement - Polaris Trail Blazer Service Manual

Hide thumbs Also See for Trail Blazer:

Table of Contents

Plastic polyethylene material must be "flame treated" prior to installing a decal to ensure good adhesion. The

flame treating procedure can often be used to reduce or eliminate the whitish stress marks that are sometimes

left after a fender or cab is bent, flexed, or damaged.

The following procedure involves the use of an open flame. Perform this procedure in a well ventilated

area, away from gasoline or other flammable materials. Be sure the area to be flame treated is clean and free of

gasoline or flammable residue.

To flame treat the decal area:

1. Pass the flame of a propane torch back and forth quickly over the area where the decal is to be applied until the

surface appears slightly glossy. This should occur after just a few seconds of flame treating. Do not hold the

torch too close to the surface. Keep the torch moving to prevent damage.

2. Apply the decal.

Polaris Sales Inc.

BODY / STEERING / SUSPENSION

Decal Replacement

99/00 ATV Update