Recoil Disassembly/Inspection - Polaris Trail Blazer Service Manual

Hide thumbs Also See for Trail Blazer:

Table of Contents

ES33PF, EH50PL Engine - Recoil Starter,

Recoil Disassembly/Inspection

CAUTION: The recoil is under spring tension. A face

shield and eye protection is required during this proce-

Replace any parts found to be worn or damaged.

1. Remove bolts and recoil housing.

2. Pull recoil rope so it is extended approximately

12-18".Check handle c-ring for proper tension, and

the handle for cracks or damage which may allow

water or dirt to enter the recoil housing through the

rope. NOTE: The handle must seal tightly on the

recoil housing to prevent water from entering.

3. Remove center bolt from recoil friction plate (A).

4. Inspect plate for wear or damage. Inspect plate

friction spring for wear, damage, and proper tension.

The spring should fit tightly on friction plate.

5. Remove ratchet pawl with spring and inspect.

Replace spring or ratchet pawl if worn, broken, or

NOTE:Long arm of spring engages reel. Short end

against pawl.

Polaris Sales Inc.