Table of Contents
Advertisement
BRAKES
Dual Hydraulic Brake Caliper
Assembly Cont.
4. Install brake pads in caliper body with friction material
facing each other. If equipped with a pad spacer, install
the spacer between the pads.
through outer pad, pad spacer and inner pad.
5. Install caliper and torque mounting bolts.
Caliper Mounting Bolt Torque
18 ft. lbs. (2.49 kg-m)
6. Install brake lines and tighten with a flare nut wrench.
7. Follow bleeding procedure outlined on pages 9.8-9.9 of
this section and refer to system overview and illustration
on page 9.6.
8. Field test unit for proper braking action before putting into
service. Inspect for fluid leaks and firm brakes. Make
sure the brake is not dragging when lever is released. If
the brake drags, re-check assembly and installation.
4/99
Install retaining pin
9.28
Spacer
Polaris Sales Inc.
Advertisement
Table of Contents
Troubleshooting
