Counter Balancer Lubrication (400Cc Engines); Procedure For Adding Oil (400); Counter Balance Oil Changing Procedure - Polaris Trail Blazer Service Manual

MAINTENANCE
Counter Balancer

Counter Balancer Lubrication (400cc Engines)

The counter balance oil should be checked semi-annually, especially before off season storage. If the machine
is used in wet conditions the oil should be checked more frequently. If the oil has a milky white or gray appearance
it should be changed as soon as possible. Failure to properly maintain this important area can result in premature
wear or possible failure of the counter balancer components. Always use SAE 10W30 oil.

Procedure for Adding Oil (400)

NOTE: Check with engine at room temperature. Do not
overfill. If overfilled, excess oil will be expelled through the
vent hose.
1. Remove seat and locate dipstick.
loosening with a long handled screwdriver.
2. Remove dipstick and wipe clean.
3. Screw dipstick in fully and remove to check.
4. Read level shown on stick.
5. Add SAE 10W30 oil with a transmission fluid funnel.
The recommended oil level is indicated by the knurled
area on the dipstick.
6. Reinstall dipstick with new sealing o-ring. Do not over
tighten.
7. Inspect counter balancer vent line for kinks or
obstructions.

Counter Balance Oil Changing Procedure

1. Remove seat. Locate and remove dipstick.
2. Remove drain plug and drain oil. Catch and discard
used oil properly.
3. Clean and reinstall drain plug.
4. Add SAE 10W30 oil using a transmission fluid funnel.
The recommended oil level is indicated by the knurled
area on the dipstick. The dipstick should be screwed in
fully to check. Do not overfill. If overfilled, excess oil will
be expelled through the vent hose.
5. Reinstall dipstick.
6. Check for leaks.
4/99
Remove by
Recommended oil level
Capacity after draining is
approximately 70 - 75cc
Screw dipstick in completely then
remove to check level.
Counter
Balance
Drain
Recoil
Drain
2.1
Dipstick
Level
Crankcase Drain
Starter
Pinion Drain
Polaris Sales Inc.