Polaris Trail Blazer Service Manual page 444

Rear Axle Installation
12. Anchor the brake lines to the swing arm using the
T--clip. Tie wrap lines together.
13. Install wheel hub, large flat washer.
14. Install cone washer with domed side facing
outward.
15. Remove jackstand and torque axle nut and wheel
nuts.
Rear Hub Nut Torque:
80 ft. lbs. (11.06 kg-m)
Rear Wheel Nut Torque
15 ft. lbs. (2.07 kg-m)
16. Install a new cotter pin. Tighten nut slightly to align
holes if required.
17. Install hub cap.
Rear Axle Bearing Removal
1. Remove left wheel and hub. (See page 7.20 of rear
axle removal, steps 1 - 7)
2. Remove rear brake caliper and support it from
machine frame.
3. Remove rear brake disc.
4. Remove and discard o--ring from axle shaft.
Polaris Sales Inc.
Shaft Ride Rear Axle Service
T--clip
7.53
FINAL DRIVE
Tie Wrap
4/99