Table of Contents
Advertisement
TRANSMISSION
Type IV, Shaft Drive Transmission
Transmission Assembly, Cont.
19. Assemble the input shaft and Hi/Low/Reverse gear
cluster as shown.
20. The two shift forks can be easily identified by the
indentations. Low/Neutral shaft has 2 detents, and
Hi/Neutral/Reverse has 3 detents.
21. Install Hi/Reverse cluster in transmission as an
assembly. If necessary use a soft face hammer to
install shafts until fully seated.
hi/reverse shift pin is located between the spring tail
ends. Place the Hi/Reverse shift assembly in neutral
position. If it is not located in neutral, the interlock
mechanism will prevent installation of the low range
shift fork in step 25.
4/99
Make sure the
8.38
Polaris Sales Inc.
Advertisement
Table of Contents
Troubleshooting
