Table of Contents
Advertisement
When the effect run control mode is enabled
By turning the Z-ring, you can run the keyframe effect,
independent of the STOP NEXT KF, EFF LOOP, and
similar settings in the keyframe control block. Turn
clockwise to run the effect in the normal direction, and
counterclockwise for the reverse direction.
When the VTR/disk recorder/frame memory operation
mode is enabled
Turning the Z-ring controls the tape transport/disk drive/
frame memory clip operations, at a speed determined by
the operating buttons. Turn clockwise for the normal
direction, and counterclockwise for the reverse direction.
When the resizer control mode is enabled
By turning the ring, you can zoom the key to which the
resizer is applied, and change the aspect ratio and
perspective.
Device Control Block (Joystick)
All functions of the joystick type device control block are
equivalent to the functions of the trackball type, except that
Region selection buttons
MENU button
Operating buttons
a Joystick
When the positioner operation mode is enabled
By moving this, you can move the pattern in the X-axis and
Y-axis directions.
When the [USER] button is selected, by turning the end of
the joystick you can adjust the size of pattern.
When the three-dimensional transform operation
mode is enabled
By moving this, you can carry out operations in the X-, Y-,
and Z-axes.
When the following buttons are held down, the joystick
operation is switched to fine control (fine mode).
• The button on the end of the joystick
48
Names and Functions of Parts of the Control Panel
When the [LOC SIZE], [LOC XYZ], or [ASP PS] button
is held down, the trackball operation is switched to fine
control (fine mode).
e MENU button
Press this button, turning it on, to enable adjusting the
parameters allocated to the knobs in the menu using the
trackball and Z-ring.
In the case of the DME menu, the operation applies to the
selected DME channel.
In VTR/disk recorder/frame memory operation mode,
press this button, setting it to On. This makes it possible to
carry out timeline start/stop point setting operation for the
device selected with the device selection buttons (timeline
setting mode).
the trackball and Z-ring operations are carried out with the
joystick.
• [SRC] button
• [TRGT] button
When the effect run control mode is enabled
By moving the joystick sideways, you can run the
keyframe effect, independent of the STOP NEXT KF, EFF
LOOP and similar settings in the keyframe control block.
Move to the right to run the effect in the normal direction,
and to the left for the reverse direction.
When the VTR/disk recorder/frame memory operation
mode is enabled
Moving the joystick sideways controls the tape transport/
disk drive/frame memory clip operation, at a speed
determined by the operating buttons.
1 Joystick
Advertisement
Table of Contents
