Table of Contents
Advertisement
Wipe Pattern Operations
in the Multifunction Flexi
Pad Control Block
Recalling a Wipe Snapshot
You can recall a wipe snapshot in the Multifunction Flexi
Pad control block.
To recall a wipe snapshot, use the operations shown in the
following illustration.
1
In the Multifunction Flexi Pad control block, press the
[WIPE] button.
This sets the Multifunction Flexi Pad control block to
wipe snapshot mode, and the button indications appear
as follows.
WIPE button
Region selection
buttons
You can change the indications for buttons [0] to [9] in
the memory recall section to pattern images, using the
Engineering Setup >Panel >Operation >Flexi Pad
Mode menu.
2
Select the region for the wipe snapshot to be recalled
with the region selection buttons.
3
Press the numeric button (lit orange) in the memory
recall section corresponding to the register in which
the desired wipe snapshot is stored.
The button you pressed lights yellow, and this recalls
the saved wipe snapshot.
At this point the numeric display shows the register
name or pattern number for the pattern.
180
Wipe Pattern Operations in the Multifunction Flexi Pad Control Block
Adjustment knobs
Alphanumeric display
Memory recall section
Selecting the Wipe Pattern
1
Press the [WIPE] button, and select the region with the
region selection buttons.
Notes
To select [M/E 4] or [M/E 5], a previous button
assignment in the Setup menu is required (see page
396).
2
Press the [PTN NO.] button in the memory recall
section.
The [PTN NO.] button lights green.
3
With the buttons in the memory recall section, enter
the pattern number of up to three digits, and press the
[ENTR] button.
This confirms the input, and the pattern number (see
page 357) appears in the alphanumeric display.
The [PTN NO.] button lights orange, and the system
returns to wipe snapshot mode.
Editing the Wipe Pattern
By pressing the [EDIT ENBL] button to switch the
memory recall section to editing mode as shown in the
following illustration, you can edit the selected wipe
pattern with the following buttons.
To exit from the editing mode, press the [EDIT ENBL]
button once more, or press the [EXIT] button.
Wipe pattern edge setting buttons
BDR (border): Applies a border to the wipe pattern.
SOFT BDR (soft border): Softens the applied border.
SOFT (soft edge): Softens the edge.
EDGE MAT (edge matte): Selects whether to fill the
edge with a color matte, or insert an image from the
utility bus. By default a color matte is selected.
You can adjust the parameters selected with these buttons
using the control knobs, when the button is lit green.
Advertisement
Table of Contents
