Table of Contents
Advertisement
Banks and registers
To allow operations on the 99 registers, the standard type
Flexi Pad control block treats the registers in groups. These
groups are called banks, and there are 10 banks, numbered
from 0 to 9.
For details of the correspondence between banks and
registers, see "Banks and Registers" (page 476).
Recalling a Macro Register and
Executing a Macro
Carrying out a macro operation in the
normal mode
Use the following procedure to recall a macro register.
1
In the Flexi Pad control block, press the [MCRO]
button, turning it on.
This assigns the Flexi Pad control block to macro
operations.
The numeric display shows the previously selected
bank number and the last recalled register number.
2
Use any of the following operations to select the bank
for recall.
To select bank 0: Press the [BANK0] button.
To select bank 1: Press the [BANK1] button.
To select any of banks 0 to 9: Press the [BANK SEL]
button, changing the memory recall section
display as in the following figure; select a number
from 0 to 9.
The selected bank number appears in the numeric
display.
Each button in the memory recall section shows
the corresponding register name and register status
for the selected bank.
Note that in the Setup menu, you can select
whether to display register names or register
numbers.
- Lit orange: Register holding macro data
- Lit yellow: Last recalled register
- Off: Empty register
3
Press the button in the memory recall section showing
the name of the register to be recalled.
The button you pressed lights yellow, the macro
register is recalled, and the macro is executed.
During macro execution, the button you pressed
remains yellow, but flashes. When macro execution
completes, it returns to permanently on.
The numeric display shows the bank name followed
by the selected register number.
Notes
• It is not possible to execute more than one macro at
a time.
• If the same register is recalled again during macro
execution or when the macro is paused, the
following operation depends on a setting in setup.
For details of the settings, see "Setting the Macro
Execution Mode" (page 606).
• Individual events stored in a macro are executed
according to the settings in setup. If you change the
settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control
executed stops.
• During macro editing it is not possible to execute a
macro.
• While executing a macro with the numeric keypad
control block, Multifunction Flexi Pad control
block, Flexi Pad control block for another switcher
bank, or with a button with a macro attachment set,
if you recall another macro with the Flexi Pad
control block, the following operation depends on a
setting in setup (see page 606).
Executing a macro in normal execution
mode (with pause events set)
When execution of a macro is paused, the [TAKE] button
is assigned to the memory recall section.
To restart the macro execution, press the [TAKE] button.
You can switch the normal execution mode and step
execution mode in the Setup menu (see page 606).
Executing a macro in step execution mode
To recall a macro register and execute the macro in step
execution mode, use the following procedure.
1
In the Flexi Pad control block, recall the macro register
(see page 505).
The Flexi Pad control block memory recall section is
assigned to the display of the [TAKE] button and
macro execution status, as in the following figure.
Macro Operations in the Standard Type Flexi Pad Control Block
505
Advertisement
Table of Contents
