Basic Procedure For Dme Wipe Settings; Dme Wipe Settings Menu; Dme Wipe Pattern Selection - Sony MVS-8000X SystemMVS-7000X System User Manual

- MVS-8000X
Key to DME wipe
Applicable
which pattern for
block
DME background
effects
are
applied
Other than Keys 1 No DME
M/E-4 to 4 wipe used
One-channel
mode
Two- or
three-
channel
mode
Keys 5 -
to 8
M/E-4 Keys 1 No DME
to 4 wipe used
One-channel
mode
Two- or
three-
channel
mode
Keys 5
-
to 8
- MVS-7000X
Key to DME wipe pattern
which
for background
DME
effects are
applied
Keys 1 to 4 No DME wipe used
One-channel mode
Two- or three-
channel mode
Keys 5 to 8 -
a) 0 when the system signal format is 1080P.
b) 1 when the system signal format is 1080P and the DME input/output
signal format is set to dual link mode.
c) 0 when the system signal format is 1080P and the DME input/output
signal format is set to dual link mode.
Basic Procedure for DME
Number of keys
to which DME
Wipe Settings
effects can be
applied
simultaneously
You carry out DME wipe setting operations principally
2 using the DME Wipe menu for each bank.
This section describes the basic procedures for DME wipe
settings, taking the M/E-1 >DME Wipe menu as an
1
example.
0
For details of independent key transition DME wipe
settings, see "DME Wipe Settings for Independent Key
Transitions" (page 193).
a)
2
For details of resizer DME wipe, see "Resizer DME Wipe
Setting" (page 195).
b)
2
c)
1

DME Wipe Settings Menu

0
Accessing the DME Wipe menu
To access the M/E-1 >DME Wipe menu, use either of the
0
following operations.
• In the menu control block, select the top menu selection
Number of keys to
which DME effects
can be applied
To select [M/E 4] or [M/E 5], a previous button
simultaneously
assignment in the Setup menu is required (see page 396).
2
• In the transition control block of the M/E-1 bank, press
1
the transition type selection button [DME] twice in rapid
0
succession.
a)
2

DME Wipe Pattern Selection

Selecting a DME wipe pattern by a menu
operation
1
2
In the M/E-1 >DME Wipe menu, select HF1 '1ch' for
one-channel mode, HF2 '2ch' for two-channel mode
or HF3 '3ch' for three-channel mode.
Select the desired DME wipe pattern group with one of
the following buttons.
• Slide/Squeeze: slide and squeeze
• Split/Door: split and door
• Flip Tumble: flip tumble
• Mirror/Sphere: mirror and sphere
• Character Trail: character trail

Basic Procedure for DME Wipe Settings

187