Table of Contents
Advertisement
settings in this list will be saved as keyframe point
data. The right list is for selecting the action.
2
Select the P-Bus device for which you want to set an
action, by using any of the following methods to
specify the device ID.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1
ID
3
Using either of the following methods, select the
action.
• Press directly on the list on the right of the status
area.
• Turn the knob.
Knob Parameter Adjustment
2
Action No
a) 1: Off (no specification)
2: Store
3: Recall
4: Trigger
4
If in step 3 you selected 2 (Store), 3 (Recall), or 4
(Trigger), turn knob 3 to select the register number or
trigger number.
The indication for knob 3 changes to reflect the
selection of Store, Recall, or Trigger.
Knob Parameter Adjustment
3
Store No
3
Recall No
3
Trigger No Trigger number
The setting is reflected in the list on the right of the
status area.
5
Press [Set].
For the device selected in the list on the left of the
status area, this sets the action specified in step 4.
Repeat steps 2 to 5 as required for other devices.
Testing an action command
To produce a test output of the action command, press
[Test Fire].
The action command is output from the 9-pin serial port of
the DCU according to the setting in the list on the left of
the status area.
418
Control of P-Bus Devices
Setting values
Device number
0 to 23
Setting values
a)
1 to 4
Action
Setting values
Register number
1 to 250
for Store
Register number
1 to 250
for Recall
0 to 15
Clearing an action setting
To clear the setting for separate devices
1
In the list on the left of the status area, select the device
for which you want to clear the action setting.
2
In the list on the right, select "Off."
3
Press [Set].
To clear the action settings for all devices in a
single operation
Press [All Off].
Setting the action for a rewind operation
On the P-Bus timeline, when the [REWIND] button in the
keyframe control block is pressed the action set for the first
keyframe is not executed; when the [RUN] button is
pressed, then the first keyframe action is executed.
To execute an action when the [REWIND] button is
pressed, it is necessary to set this action (Rewind Action).
To carry out this setting, in the Device >P-Bus Timeline
menu, press [Rewind Action] to recall the Rewind Action
menu. In this setting screen, use the same setting method
as in the screen for setting an action on the P-Bus timeline.
Alternatively, you can select the reverse arrangement,
whereby when the [REWIND] button is pressed, this
executes the action set for the first keyframe, and when the
[RUN] button is pressed the first keyframe action is not
executed. In this case, the Rewind Action setting is still
valid.
For details, see "Setting the First Keyframe When a
Rewind is Executed" (page 603).
Carrying out a Direct Store
You can carry out a Learn with the register number
specified for the device selected in the menu.
1
Using any of the following methods, select the device.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Setting
1
ID
Device ID
2
In the Device >P-Bus Timeline menu, press [Direct
Store].
The numeric keypad window appears.
Setting values
0 to 23
Advertisement
Table of Contents
