Table of Contents
Advertisement
KEY PRIOR button
Next transition selection buttons
PRIOR SET button
Transition control block (standard type)
Changing the currently inserted key
priority
1
If the next transition selection button [KEY PRIOR] is
on, press another next transition selection button to
turn the [KEY PRIOR] button off.
When the [KEY PRIOR] button is on, the transition
control block switches to the mode for changing the
key priority for after the transition.
2
Holding down the [PRIOR SET] button, press the one
of the next transition selection buttons [KEY1] to
[KEY4] ([DSK1] to [DSK4] buttons in the PGM/PST
bank) for the key to appear on top.
Notes
• To select [Key5] to [Key8], or [DSK5] to [DSK8]
requires an assignment (see page 397).
• The key priority establishes a separate priority order
within each of the groups of keys 1 to 4 and keys 5
to 8. You can make any setting within the groups of
keys 1 to 4 or keys 5 to 8, but not for combinations
of keys from different groups.
For example, it is not possible to set a priority
sequence of keys 1, 5, and 2.
The selected key now appears on top, on the program
monitor.
The priority of keys other than the selected one does
not change.
Key priority: 3, 1, 4, 2
Key priority: 1, 3, 4, 2
To change the priority of more than one key, repeat
this operation as required.
Changing the key priority for after the
transition
When executing a transition, turning on the next transition
selection button [KEY PRIOR] causes the keys to be
rearranged based on the set priority.
To set the key priority for after the transition, use the
following procedure.
1
In the transition control block, hold down the [PRIOR
SET] button and press the [KEY PRIOR] button to
turn it on. Do not release the [PRIOR SET] button
before advancing to step 2.
The [KEY PRIOR] button lights green, and it becomes
possible to change the key priority setting for after the
transition.
2
Hold down the [PRIOR SET] button, and press the one
of the next transition selection buttons [KEY1] to
[KEY4] ([DSK1] to [DSK4] buttons in the PGM/PST
bank) for the key you want to bring to the front after
the transition.
To set the priority to be the same as before the
transition, press the [BKGD] button.
Notes
• The [BKGD] button is only effective when in the
mode for changing the key priority for after the
transition.
Key 1 selected.
99
Key Priority Setting
Advertisement
Table of Contents
