Table of Contents
Advertisement
Independent Key Transition Control
Block (Simple Type)
The left side of this control block controls key 3, and the
right side controls key 4.
The control block for key 3 only is described as an
example, but the operations on the key 4 control block are
the same.
In setup you can assign any key to either side of this
control block.
You can also assign the key selection function (key
delegation) for keys 1 to 8 to any buttons in this control
block.
For details, see "Assigning Keys to the Independent Key
Transition Control Block (Simple Type)" in Chapter 19
(Volume 2).
3 K-SS button
4 Key source name display/key
snapshot buttons
2 Independent key transition
execution section
1 Independent key transition type
selection buttons
a Independent key transition type selection buttons
Press one of the following buttons, turning it on, to select
the independent key transition type.
Name
Description
MIX
Faded in or out.
WIPE
Inserted or deleted with a wipe.
Name
Description
DME
Switches the key with a DME wipe.
CUT
Inserted or deleted instantaneously.
• When setting is made in the Setup menu to
SHIFT
allow a different transition type for inserting
or deleting a key, it is possible to display and
set the transition type after the next
transition while this button is held down.
• While this button is held down, you can
select a key source with the cross-point
buttons for the key bus.
• If you press this button twice in rapid
succession, the key bus selection button
[KEY3] in the cross-point control block
lights, and a key 3 key bus cross-point can
be selected.
• If you press this button, while holding down
the [TRANS RATE] button in the numeric
keypad control block, you can set the
independent key transition rate on the
control block.
b Independent key transition execution section
The following buttons are used to carry out independent
key transition operations.
Name
Description
• This inserts or deletes key 3
KEY3 ON
instantaneously.
• When key 3 is present in the final program
output from the switcher, this lights red, and
otherwise lights amber.
TAKE
This carries out an auto transition on key 3.
c K-SS (key snapshot) button
This enables key snapshot mode. In key snapshot mode, it
is possible to save and recall key snapshots.
d Key source name display/key snapshot buttons
These show the signal name of the key fill selected for key
3 and the transition rate on two buttons. In key snapshot
mode, these correspond to registers 1 and 2 for key 3; press
to save or recall a key snapshot.
To save a key snapshot, with the [K-SS] button lit amber,
hold down [SHIFT] button and press one of the key
snapshot buttons.
This saves a key snapshot in the button you pressed, which
lights yellow.
By assigning [K-SS 3/4] to a key in the Setup menu, you
can press the button to switch between key snapshot
registers 1/2 and 3/4.
Names and Functions of Parts of the Control Panel
65
Advertisement
Table of Contents
