Dme Wipe Pattern Operations In The Multifunction Flexi Pad Control Block; Recalling A Dme Wipe Snapshot; Selecting The Dme Wipe Pattern; Editing The Dme Wipe Pattern - Sony MVS-8000X SystemMVS-7000X System User Manual

DME Wipe Pattern
Operations in the
Multifunction Flexi Pad
Control Block

Recalling a DME Wipe Snapshot

The operation of recalling a DME wipe snapshot in the
Multifunction Flexi Pad control block is the same as the
operation of recalling a wipe snapshot, except for pressing
the [DME WIPE] button to select DME wipe snapshot
mode (see page 180).
You can change the indications for buttons [0] to [9] in the
memory recall section to pattern images, using the
Engineering Setup >Panel >Operation >Flexi Pad Mode
menu.

Selecting the DME Wipe Pattern

The operation of selecting the DME wipe pattern in the
Multifunction Flexi Pad control block is the same as the
operation of selecting a wipe pattern, except for pressing
the [DME WIPE] button to select DME wipe snapshot
mode (see page 180).
Note, however, that the pattern numbers for DME wipe
patterns have four digits (see page 361).

Editing the DME Wipe Pattern

By pressing the [EDIT ENBL] button to switch the
memory recall section to editing mode as shown in the
following illustration, you can edit the selected DME wipe
pattern with the following buttons.
To exit from the editing mode, press the [EDIT ENBL]
button once more, or press the [EXIT] button.
200

DME Wipe Pattern Operations in the Multifunction Flexi Pad Control Block

Note that the operation of the following buttons is the same
as when editing a wipe pattern.
• [EXIT] button
• [PTN LIMT], [LIMT SET] buttons
• [NORM], [NORM/REV], [REV] buttons
• [KNOB 1/2] button
For the method of operation of these buttons, see "Editing
the Wipe Pattern" (page 180).
Channel selection buttons
1ST CH (channel 1): Selects channel 1.
2ND CH (channel 2): Selects channel 2.
You can also select two channels by pressing the buttons
simultaneously.
DME wipe pattern edge setting buttons
BDR (border): Applies a border to the DME wipe pattern.
SOFT BDR (soft border): Softens the applied border.
You can adjust the parameters selected with these buttons
using the control knobs, when the button is lit green.
• When border is selected
Knob Parameter Adjustment
1 W Border width
2 L Luminance
3 S Saturation
4 H Hue
• When soft border is selected
Parameter group [1/2]
Knob Parameter Adjustment
1 W Border width
2 I Degree of
softening of
inside of
border
Setting values
0 to 100
0 to 100
0 to 100
0 to 359
Setting values
0 to 100
0 to 100