Device Control Block (Joystick) - Sony G363-ZR0-LAX1 User Manual

Device Control Block (Joystick)

All functions of the joystick type device
control block are equivalent to the functions
of the trackball type, except that the
MENU button
a Joystick
When the positioner operation mode is
enabled
By moving this, you can move the pattern
in the x-axis and y-axis directions.
When the three-dimensional transform
operation mode is enabled
By moving this, you can carry out
operations in the x-, y-, and z-axes.
When the following buttons are held down,
the joystick operation is switched to a finer
control. (fine mode)
• The button on the end of the joystick
• [SRC] button
• [TRGT] button
238
Names and Functions of Parts of the Control Panel
Region selection buttons
M/E1 M/E2 M/E3 P/P USER
DME1 DME2 DME3 DME4
RUN
DME5 DME6 DME7 DME8
CTRL
LOCAL GLB
SRC TRGT
MENU K1 K2
K3 K4
CB1 CB2
AXIS ASP LOC LOC ROT
LOC PERS SIZE XYZ POS
MAIN SUB ASP LOC RSZR
CLR
SHIFT WORK X Y Z
BUFR
Operating buttons
trackball and Z-ring operations are carried
out with the joystick.
1 Joystick
DEV
RSZR
CTRL
CTR
Depending on the settings made in the
Setup menu, the operation speed multiple
can be changed.
When the effect run control mode is
enabled
By moving the joystick sideways, you can
run the keyframe effect, independent of the
STOP NEXT KF, EFF LOOP, and similar
settings in the keyframe control block.
Move to the right to run the effect in the
normal direction, and to the left for the
reverse direction.