Table of Contents
Advertisement
Color Corrector
Preparations
The color corrector enables video signal color correction
(black balance/white balance adjustment, gamma
correction, knee correction, etc.).
Notes
To use the color corrector, the BZS-8420X (for MVS-
8000X) or the BZS-7420X (for MVS-7000X) Color
Corrector Software is required. To use the software, you
are required to input an install key.
For the method of inputting an install key, see
"Installation and Device Setup (Install/Unit Config
Menu)" in Chapter 18 (Volume 2).
240
Preparations
Chapter
Restrictions on color corrector and M/E
combination
Signal
When the color corrector
format
output is selected
3M/E system
4M/E to 6M/E
systems
–
Other
Reentry signal
than
selection on a
720P
key bus or the
utility 1 bus
cannot be
performed over
a cascade of
two or more M/
E blocks
(Restriction 2).
720P
Reentry signal
Reentry signal
selection on a
selection on a
key bus or the
key bus or the
utility 1 bus
utility 1 bus
cannot be
cannot be
performed over
performed
a cascade of
(Restriction 1).
two or more M/
E blocks
(Restriction 2).
Example of restriction 2: When M/E-1 is selected on the
M/E-2 background A bus (or background B bus, key
bus, or utility 1 or 2 bus), then M/E-2 cannot be
selected on the M/E-3 key bus or the utility 1 bus.
Assigning the color corrector input buses
to AUX delegation buttons
There are two inputs for capturing material to the color
corrector: the CCR1 bus and the CCR2 bus.
For details of the input assignment operation, see
"Auxiliary Bus Control Block Settings (Aux Assign
Menu)" in Chapter 19 (Volume 2).
9
When the
color corrector
output is not
selected
4M/E to 6M/E
systems
–
Reentry signal
selection on a
key bus or the
utility 1 bus
cannot be
performed over
a cascade of
three or more
M/E blocks
(Restriction 2).
Advertisement
Table of Contents
