Device Control Block (Joystick) - Sony CCP-8000 Series User Manual

Device Control Block (Joystick)

The description below of frame memory
clip operations applies only to the MVS-
8000A/8000G.
MENU button
a Joystick
When the positioner operation mode is
enabled
By moving this, you can move the pattern
in the x-axis and y-axis directions.
When the three-dimensional transform
operation mode is enabled
By moving this, you can carry out
operations in the x-, y-, and z-axes.
When the following buttons are held down,
the joystick operation is switched to a finer
control. (fine mode)
66
Names and Functions of Parts of the Control Panel
All functions of the joystick type device
control block are equivalent to the functions
of the trackball type, except that the
trackball and Z-ring operations are carried
out with the joystick.
Region selection buttons
Operating buttons
• The button on the end of the joystick
• [SRC] button
• [TRGT] button
Depending on the settings made in the
Setup menu, the operation speed multiple
can be changed.
When the effect run control mode is
enabled
By moving the joystick sideways, you can
run the keyframe effect, independent of the
STOP NEXT KF, EFF LOOP, and similar
settings in the keyframe control block.
1 Joystick