Table of Contents
Advertisement
System Settings
Run/Hold
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the
results of a specific measurement sweep.
The current sweep mode is shown on the screen as:
-
- Hold
-
How to perform a single sweep while in Hold
- Press Sweep 3.
- Then choose one of the following:
208
"Frequency Reference Source" on page 226
"Security Level" on page 227
"Date and Time, Format, and Time Zone Settings" on page 227
"System Information" on page 235
"LAN Settings" on page 231
"Power ON" on page 232
"Service Diagnostics" on page 235
"Install the Lithium-Ion Battery" on page 22
"FieldFox High Temperature Protection" on page 24
Continuous
is displayed while a single sweep occurs.
-Single
Automatically sets Continuous OFF (Hold) and causes FieldFox
to make ONE measurement sweep, then hold for the next Single key
press.
-Continuous ON OFF
setting when battery power is not critical.
Makes continuous sweeps. This is the typical
Keysight N9923-90001 User's Guide
Advertisement
Table of Contents
