Table of Contents
Advertisement
NA (Network Analyzer) Mode
NA Mode Settings
Magnitude Offset
Magnitude Offset allows you to offset the magnitude (not phase) data by a
fixed and/ or sloped value in dB. If the display format is Linear Magnitude or
Real (unitless), the conversion from dB is performed and the correct amount of
offset is implemented.
The Magnitude offset setting affects only the active trace.
How to set Magnitude Offset
— Press Scale / Amptd
— Then
— Then
— And/or press
Electrical Delay
Electrical delay is a mathematical function that simulates a variable length of
lossless transmission line. Use the electrical delay feature to compensate for
the linear phase shift through a device and view only the deviation from linear
phase of the device.
You can set the electrical delay independently for each measurement trace. To
apply an electrical delay to all measurement traces, use Port Extensions. Learn
how in
Learn how to set Phase formats in
How to set Electrical Delay
— Press Scale / Amptd
— Then
— Then
Keysight N9923-90001 User's Guide
More
Magnitude Offset
value.
—Then enter a positive or negative offset value in dB using the numeric
keypad, the
Learn about multiplier abbreviations in
page
34.
Slope
- Offsets the data trace by a value that changes linearly
with frequency. The offset slope begins at 0 Hz. and continues to the stop
frequency. The offset value at the start frequency is then calculated from 0
Hz.
—Then enter a positive or negative offset slope value in dB/GHz using
the numeric keypad, the
multiplier key. Learn about multiplier abbreviations in
Abbreviations" on page
"Port Extensions" on page
More
Electrical Delay
- Offsets the entire data trace by the specified
arrows, or the rotary knob. Press a multiplier key.
"Multiplier Abbreviations" on
arrows, or the rotary knob. Press a
34.
54.
"Phase Offset" on page
"Multiplier
50.
49
Advertisement
Table of Contents
