Table of Contents
Advertisement
System Settings
System Configuration
For all A.08.15 and A.09.15 FW and above, when using Static IP addresses:
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
— Static Gateway - Enter the Static Gateway – including periods - in the
— Static DNS - Enter the Static DNS – including periods - in the format
— Apply Settings Choose from:
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
— Press
Power ON
When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.
How to set Power ON
— Press System 7
— Then
— Then
— Then
— Then choose from the following:
230
— Static IP Address - Enter the IP Address – including periods - in the
format nnn.nnn.nnn.nnn
— Either a valid Static Gateway is required or 0.0.0.0.
— Either a valid Static DNS is required or 0.0.0.0.
format nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn6
—Power Up The above settings take effect when the FieldFox is started.
—Now The above settings take effect immediately.
Done Ed it
when finished.
System Configuration
More
Power ON
—Auto
The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
—Manual
The FieldFox will power ON only when the power button is
pressed.
Keysight N9923-90001 User's Guide
Advertisement
Table of Contents
