Power On; How To Set Power On - Keysight N9923A User Manual

System Settings

Power ON

— Static IP Address - Enter the IP Address – including periods - in the format
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
— Static Gateway - Enter the Static Gateway – including periods - in the
— Apply Settings Choose from:
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
— Press

Power ON

When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.

How to set Power ON

— Press System 7.
— Then
— Then
— Then choose from the following:
232
—DHCP - IP Address is assigned dynamically. If your server supports this
feature, the IP Address for the FieldFox is assigned each time it is
started.
—Static - Set the IP Address manually. The Address remains until you
change it.
nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
—Power Up The above settings take effect when the FieldFox is started.
—Now The above settings take effect immediately.
Done Ed it when finished.
System Configuration.
Power ON.
Auto
— The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
Manual
— The FieldFox will power ON only when the power button is
pressed.
Keysight N9923-90001 User's Guide