How To Save And Recall Limits - Keysight N9923A User Manual

Data Analysis Features
All about Limit Lines
— Then Options.
— Then choose from the following:

How to Save and Recall Limits

In addition to saving and recalling limits with an *.sta file, limit lines can also be
saved and then recalled independent of the current mode or measurement.
Use this feature to recall and apply existing limit lines to measurements with
different settings or even a different frequency range.
Limit line files can be loaded into the FieldFox Data Link Software. Learn how in
the Help file that is included in the Data Link software.
— Press Save/Recall then
— Then press Limit.
— Then choose from the following:
188
—Beep
——On Pass
Audible beep sounds when a sweep passes.
——On Fail Audible beep sounds when a sweep fails.
——Off No audible beep sounds.
—Warning On Off Shows Pass or Fail indication on the display with each
sweep. Data points that fail are highlighted.
—Limit Type
Then Fixed or Relative.
—Offset Shifts the limit line up or down. Enter an offset value using the
rotary knob, the
keys.
——Enter a positive offset to shift the limit line UP, usually used
with UPPER limits.
——Enter a negative offset to shift the limit line DOWN, usually
used with LOWER limits.
—Margin Shifts the limit line up or down like an offset, but only virtually.
The limit line does NOT appear to move. Enter a Margin value using
the rotary knob, the
number keys.
Enter a positive margin to virtually shift the limit line UP.
Enter a negative margin to virtually shift the limit line DOWN.
or USB flash drive) to be used for the Save or Recall. Learn more in
Type and Select Device" on page
Save Limits
— After limit lines have been defined, this saves the line
definition to a file on the specified device.
Recall Limits
— Recalls a limit Line definition from the specified device.
arrows, or by entering a value with the number
arrows, or by entering a value with the
Select Device
to set the Device (Internal, SD card,
196.
Keysight N9923-90001 User's Guide
"Set File