Table of Contents
Advertisement
NA (Network Analyzer) Mode
NA Mode Settings
How to set Output Power
— Press Meas Setup 4.
— Then
System Impedance (Z0)
To accurately view data presented in Smith Chart format, first set the System
Impedance.
Learn how to select Smith Chart format in
Learn how to make 75Ω measurements at the FieldFox Supplemental Online
Help:
How to set System Impedance
— Press Meas Setup 4.
— Then Settings.
— Then scroll to System Z0 and press
— Then type either 50 or 75 and press
Port Extensions
Port extensions allow you to electrically move the calibration reference plane
on either port 1 or port 2 after you have performed a calibration.
54
Output Power
— High Sets output power to the maximum achievable power at all
displayed frequencies. Output power is NOT FLAT across the
displayed FieldFox frequency span. Please see
Sheet" on page 263
— Low Sets output power to approximately –45 dBm, FLAT across the
displayed FieldFox frequency span.
— Man (default setting at -15 dBm) Set output power to an arbitrary
value, FLAT across the displayed FieldFox frequency span. If flattened
power can NOT be achieved, a warning message and beep occurs. To
achieve a flattened output power, reduce the power level or stop
frequency.
Power Level
— Then press
— Then enter a value using the numeric keypad, the
rotary knob.
— Press Enter.
http://na.support.keysight.com/fieldfox/help/SupHelp/FieldFox.htm
for expected power levels.
"Format" on page
Ed it
Enter
Keysight N9923-90001 User's Guide
"Specifications/Data
arrows, or the
46.
Advertisement
Table of Contents
