Over Heat - Xerox Phaser 6280 Service Manual

Over Heat

Phaser 6280 Color Laser Printer Service Manual
The Temperature Sensor has detected high temperature.
Applicable Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feeder Assembly, PL3.2.1
MCU Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the room temperature.
2. Is the room temperature over
32° C?
1. Check the print usage.
2
2. Did the user print a large volume of
document?
3 1. Allow the printer to cool down for
about five minutes.
2. Does the error still occur?
4 1. Check the MCU Board for correct
installation. Reseat the MCU Board
(page 8-86).
2. Does the error still occur?
1. Replace the MCU Board
5
(page 8-86).
2. Does the error still occur?
042-700: IOT Over Heat Stop
142-700: IOT Over Heat Forced Half Speed
Wiring and Plug/Jack Map References
Error Messages and Codes
Yes No
Change the Go to step 2.
room
temperature or
move the printer
to a different
location.
Go to step 3. Go to step 4.
Go to step 4. Complete.
Go to step 5. Complete.
Replace the Complete.
Feeder
Assembly
(page 8-36).
3-119