Optional Feeder Motor Error - Xerox Phaser 6280 Service Manual

Error Messages and Codes

Optional Feeder Motor Error

Applicable Chain Link
Initial Actions
3-126
The Optional Feeder Motor has failed.
Chain Link 042-325-04: IOT Motor Failure
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.1.20
Feed Roll, PL12.1.9
Retard Roll, PL12.3.10
Right Side Harness, PL10.1.15
Optional 550-Sheet Feeder, PL12.1.1
Feeder Unit Harness, PL12.2.3
Tray 3 Feeder Board, PL12.2.6
C2 Motor Harness, PL12.2.9
Tray 3 Feeder Drive, PL12.2.10
Tray 3 Feeder Assembly, PL12.3.1
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the detailed error code (press
the Up and Down buttons
simultaneously).
2. Does code "04" display on the
Control Panel?
1. Check the paper tray for correct
2
installation.
2. Is the tray correctly installed?
3 Does the error still occur?
4 1. Check the Feed Rollers and Retard
Rollers for rotation.
2. Do the Rollers rotate smoothly?
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-10
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Map 6 - Optional 550-Sheet Feeder" on
page 10-14
"Optional 550-Sheet Feeder Wiring
Diagram" on page 10-39
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Go to step 5.
Phaser 6280 Color Laser Printer Service Manual
No
Refer to
"Main Motor
Error" on
page 3-120
Refer to "Sub
Motor Error" on
page 3-122
Refer to "Tray
2 (PH) Motor
Error" on
page 3-124
Reseat the
paper tray.
Go to step 3.
Complete.
Replace the
defective
Roller(s).