Deve Mode Error - Xerox Phaser 6280 Service Manual

Deve Mode Error

Phaser 6280 Color Laser Printer Service Manual
The Deve Mode (K Mode) change failure has been detected.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
K Drive Assembly, PL8.1.10
MCU Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Perform the K Mode Solenoid test
(page
Engine Diag > Motor Test
Clutch
Front Cover.
2. Does the K Mode Solenoid make a
clicking sound?
1. Check the K Drive Assembly for
2
correct installation. Reseat the K
Drive Assembly (page 8-76).
2. Does the error still occur?
3 1. Check the wiring harness
connectors P/J20 and P/J201
between the MCU Board and the K
Mode Sensor.
2. Are the connectors securely
connected?
4 Does the error still occur?
042-372: IOT Deve Mode Change Failure
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-9
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Main Drive" on page 10-25
4-64): Service Mode >
> K Mode
On. During the test, close the
Error Messages and Codes
Yes No
Go to step 2. Go to step 8.
Go to step 3. Complete.
Go to step 5. Reconnect the
connectors.
Go to step 4.
Go to step 5. Complete.
3-117