Jam At Duplexer - Xerox Phaser 6280 Service Manual

Color laser printer
Hide thumbs Also See for Phaser 6280:
Table of Contents

Advertisement

Jam at Duplexer

Phaser 6280 Color Laser Printer Service Manual
The Duplex Jam Sensor indicates the paper did not reach the sensor on time
or that paper remains in the Chute Assembly Out.
Applicable Chain Link
Chain Link
Initial Actions
Check for obstruction or debris in the Exit Chute Out or paper path.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover Harness, PL1.2.11
Feeder Assy., PL3.2.1
Registration Sensor Harness,
PL3.2.37
Exit Out Chute, PL6.1.1
Fuser Harness, PL6.1.11
Duplex Gate Chute, PL6.1.13
Main Drive Assy., PL8.1.2
PH Drive Assy., PL8.1.7
MCU Board, PL9.1.20
Right Side Harness, PL10.1.15
Duplex Unit, PL11.1.1
Duplex Harness, PL11.1.18
Troubleshooting Procedure Table
Step
Actions and Questions
1. Check the Front Cover Latch. Open
1
and close the Front Cover.
2. Does the error still occur?
1. Reseat the Fuser (page 8-11).
2
2. Does the error still occur?
3
1. Reseat the Duplex Gate Chute
(page 8-64).
2. Does the error still occur?
077-907: IOT Remain Duplex Jam
Wiring and Plug/Jack Map Reference
"Map 1 - Electrical and Drive" on
page 10-9
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-10
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Map 5 - Duplex Unit" on page 10-13
"Tray 1 (MPT) and Registration" on
page 10-23
"Main Drive" on page 10-25
"Feeder" on page 10-27
"Fuser" on page 10-35
"Duplex Wiring Diagram" on page 10-41
Error Messages and Codes
Yes
No
Go to step 2.
Complete.
Go to step 3.
Complete.
Go to step 4.
Complete.
3-47

Advertisement

Table of Contents
loading

Table of Contents