Adc Sensor Error (Low Density) - Xerox Phaser 6280 Service Manual

ADC Sensor Error (Low Density)

Phaser 6280 Color Laser Printer Service Manual
The ADC Sensor has detected low density error.
Applicable Chain Link
Chain Link
Initial Actions
Ensure the Transfer Unit and surrounding area is free of waste toner.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover Harness, PL1.2.11
Transfer Unit, PL4.1.1
Laser Unit, PL5.1.2
Print Cartridge (C/M/Y/K),
PL5.1.18-21
Main Drive Assembly, PL8.1.2
MCU Board, PL9.1.20
Right Side Harness, PL10.1.15
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the detailed error code on the
Control Panel (press the Up and
Down buttons simultaneously).
2. Does code "02" display on the
Control Panel?
1. Check the Transfer Unit for correct
2
installation.
2. Is the Transfer Unit correctly
installed?
3 Does the error still occur?
1. Check the Print Cartridges for
4
correct installation.
2. Are the Print Cartridges correctly
installed?
5 Does the error still occur?
092-651: IOT ADC Sensor Error
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-9
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Xerographic" on page 10-30
Error Messages and Codes
Yes No
Go to step 3. Go to step 13.
Go to step 4. Reseat the
Transfer Unit
(page 8-8).
Go to step 3.
Go to step 4. Complete.
Go to step 6. Reseat the Print
Cartridge(s)
(page 8-10).
Go to step 5.
Go to step 6. Complete.
3-139