Bias Assembly (Pl5.1.13) - Xerox Phaser 6280 Service Manual

Service Parts Disassembly

BIAS Assembly (PL5.1.13)

8-58
1. Remove the Rear Cover (page 8-12).
2. Remove the Right Side Cover (page 8-13).
3. Remove the Left Side Cover (page 8-14).
4. Remove the Top Cover (page 8-15).
5. Remove the LED Assembly (page 8-60).
Note
It is not necessary to disconnect the connector on the MCU Board for the
following step.
6. Remove the HVPS (page 8-61).
Note
Keep the relay connector on the printer harness side.
7. Disconnect the Dispenser Assembly (PL5.1.12) wiring harness
connectors and release the wiring harnesses from the Motor Harness
Duct.
8. Release the 2 hooks securing the Motor Harness Duct.
9. Slightly shift the Motor Harness Duct upward to release the convex
section from the printer. Place the connectors through the hole of the
Motor Harness Duct and remove the Motor Harness Duct.
Hooks
s6280-211
Phaser 6280 Color Laser Printer Service Manual