Service Parts Disassembly
K Drive Assembly (PL8.1.10)
8-76
1.
Remove the Rear Cover (page 8-12).
2.
Remove the Right Side Cover (page 8-13).
3.
Remove the Left Side Cover (page 8-14).
4.
Remove the I/P Board Shield (page 8-96).
5.
Remove the MCU Board Shield (page 8-94).
6.
Disconnect wiring harness connector P/J20 on the MCU Board
(PL9.1.20).
7.
Release the K Mode Sensor wiring harness from the 5 clamps and route
the wiring harness through the hole to remove it.
Phaser 6280 Color Laser Printer Service Manual
P/J20
s6280-230