Script Files; Loading Script Files - GSE 60 SERIES Technical Reference Manual

P9994: Macro Table Limited Access
Enables the contents of the macro table to be blocked from viewing,
downloading or editing if only the limited access code specified at P402
was used to enter the setup mode.
P10001: Macro Entry Table
Begins the macro program table.
M D
ACRO EBUG
The macro debug parameters provide access to the macro debug table for
program diagnostics.
P50000: Macro Debug Table Limited Access
Enables the contents of the macro debug table to be blocked from viewing,
downloading or editing if only the limited access code specified at P402
was used to enter the setup mode.
P50001: Macro Debug Table
Begins the macro debug diagnostic table. Press [PRINT] and select a
comm port to download the macro debug to a printer or PC for analysis.
Pressing [ID] (or [PRINT] + [SELECT] on the 460) at P50001 will briefly
display the total number of bytes allocated for the macro trace buffer
(Bsize) followed by the number of bytes used (Bused). If no macros are
programmed both numbers will be zero (0).
S F
CRIPT ILES
Script files are pre-programmed setup files residing within the firmware
that can be loaded to perform various applications. Script file parameters,
macros, custom transmits, etc. are loaded into the setup parameters
directly from the firmware by defaulting the indicator to a script file
selection.
L S
OADING CRIPT
To load a script file:
1. Access the setup mode using the setup access code.
2. Select the Default All parameter (P65001).
3. Press [TARE] or [UNITS] on the 465, 560 and 660 Series or [ZERO] +
[PRINT] or [UNITS] on the 460 to scroll forward and backward through
the available script files.
4. When the desired script file is displayed, press [ENTER] to initiate the
default process.
5. When the default is complete, exit and save changes to begin using
the script file software.
Setup Parameters 3-45
F
ILES
60 Series Technical Reference Manual