GSE 60 SERIES Technical Reference Manual page 287

Motion Delay
Suspends macro execution until a stable weight is achieved as determined
by the settings for P114 (motion divisions) and P115 (motion delay).
M0%, Pause during motion on the currently selected
scale.
M1%, Pause during motion on scale 1.
M*%, Pause during motion on all scales. All scales must
be stable before macro execution will resume.
M1;Mot'nDelay%, Display "Mot'n Delay" while pausing for motion on
scale 1.
P S
%-
ERFORM
Syntax Perform Scale Specific Function
< `|t|u|z > S < scale# > [ ;argument ] %-
Arguments
` Scale select
t Tare
u Units
z Zero
Scale number (1 à 8).
scale#
argument Valid argument to the %`, %t, %u or %z command.
Notes The %- command is mode independent. Use caution
when using this command to ensure the scale for which
the function is intended will not be performing a critical
function at the time the function is executed.
This command replaces the 660 Series mode independent
commands previously available with the %`, %t, %u and
%z commands.
See Also %` Scale Select
%t Tare
%u Units
%z Zero
Perform Scale Specific Function
Performs a mode independent scale-select, tare, units or zero function on
a specific scale. These functions can be performed on the currently
selected scale as well as all other enabled scales regardless of the current
mode of operation. Motion delayed commands will be motion delayed for
the intended scale whether or not it is the currently selected scale.
S F
CALE PECIFIC UNCTION
60 Series Technical Reference Manual
Macros 9-39