Entering Parameter Data - GSE 60 SERIES Technical Reference Manual

8-18 Chapter 8
GSE Scale Systems
E P
NTERING ARAMETER
Operating parameters may be entered in a custom transmit table.
Parameters may be formatted to include the parameter's value, units (if
applicable) and name. See Table 7-1 on page 7-3 for a complete list of
operating parameters.
To enter a parameter into the transmit table:
1. Press [ENTER]
2. The display prompts Pick Parm:, Parm= Gross.
3. Select the desired parameter by:
Pressing [ 5 ] or [ 6 ] to scroll through the parameter list, or
-
- Keying in the parameter number and instance if applicable ( you
will be prompted Pick Inst: by the indicator if an instance is
required).
4. The display prompts Set Formt, Formt 00000.
5. Key in the desired format and press [ENTER] (see Parameter Format
Codes below).
6. The display confirms the entered format.
7. Press [ENTER] to accept the parameter configuration.
8. The formatted parameter is entered into the transmit table as a single
P
character.
A
For example, the third line of the ticket in the previous example
50.00 lb Gross
contains the gross weight value (50.00), the weigh units (lb) and the
parameter name (Gross).
To enter this parameter into the transmit table:
1. Press [ENTER]
2. The display prompts Pick Parm:, Parm= Gross.
3. Key in the gross weight parameter for scale #1, 0.1, and press
[ENTER].
4. The display prompts Set Formt, Formt 00000.
5. Press 0 [ENTER].
6. The display confirms the entered format.
7. Press [ENTER] to accept the parameter configuration.
To complete the example, enter a <CR><LF> after the gross weight
parameter and repeat steps 1 – 7 substituting the tare and net parameter
numbers at step 3. Remember the <CR><LF> control codes after each
parameter. Also include the <FF> character at the end.
D
ATA