GSE 60 SERIES Technical Reference Manual page 502

13-26 Chapter 13
GSE Scale Systems
61121%s -1070%e
61122%s 111111%e
64102%s
Operator: rg
Date:mmddyy=090610
420919-36553 Multi-scale Option Board
ATR-31565
The values indicated in bold define the A/D calibration values for the multi-
scale module. They must be keyed into and stored in their respective
parameters for accurate operation. The serial number (P61122) is
intended to allow you to associate these setup parameters to a specific
multi-scale option module. Contact GSE with the part number and serial
number of the multi-scale board if the calibration sheet is misplaced.
Refer to chapter 4 on page 4-11 for complete details on A/D calibration.
S C
CALE ALIBRATION
Load cell calibration must performed after the multi-scale module is
installed. Refer to chapter 4 for complete calibration instructions.
W M O
EIGH ODE
From the weigh mode, pressing [SCALE SELECT] will toggle the display
to the next enabled scale. Regardless of which scale is currently selected
for viewing, all enabled multi-scale modules will continue to process weight
data. Thus, any setpoints, analog outputs, custom transmits, etc. that are
based on an active weight parameter will be continuously updated
independent of any other process (i.e. other multi-scale modules, macros,
transmits, etc.).
C M
ONNECTING
It possible to install many SBMs inside the standard enclosures. Note that
the standard SBM kits supply a standard interface ribbon cable. If multiple
output devices are daisy-chained, it is possible that the cable length
supplied will reach the next device on the link. This is due in some
instances to improper positioning of the option devices. If extensive output
devices are to be used take care to install them in a manner that the
cables supplied will be adequate. Longer interface cables can be
purchased if necessary.
P61121. VREF NROff
P61122. SN:
View errors after uploading!
PERATION
SBM
ULTIPLE S
-1070
111111