Table of Contents
Advertisement
3. Remove the M4 hex bolt, if installed. Hook a finger under the edge of
the cover. Pull outward and upward to disengage the cover from the
mounting plate tabs.
4. Install the load cell leads into J2 on the main board (see Figure 2-2
and refer to page 2-19).
To re-install the rear panel:
1. Move the rear cover into position. Ensure that all of the cables are
positioned within the cutouts of the cover. Press the cover straight
towards the panel until the left and right side slots snap over the tabs
on the mounting plate.
2. Mount the rear cover, if used, to the indicator with the four 8-mm hex
head screws.
3. Install the M4 hex bolt in the upper left corner using a 7mm socket.
4. Reconnect any cables from the respective source connectors.
5. Plug the indicator into the AC power outlet socket.
6. Test the indicator for proper operation.
560
562 C
AND
Model 560 and 562 controllers are offered in standard and panel mount
versions. All general setup, calibration, and custom programming
operations of the panel-mount versions are identical to those of the
respective standard versions. Differences between the standard and
panel mount versions are mainly in the enclosure and the position of both
the main printed circuit board and display.
Standard 560 and 562 controllers have a swivel bracket for table-top use.
Panel-mount versions of the 560 and 562 controllers are designed for
permanent mounting in washdown environments and do not have a swivel
bracket. The main printed circuit board is orientated so that the
component side faces away from the display and the non-component side
faces the same direction as the keypad, allowing easy servicing. In
addition, a rear cover protects the main board and components against
physical and electrical damage.
S
560
TANDARD
The standard 560 and 562 controllers can be installed for table-top use or
permanent mounting.
T
-T
U
ABLE
OP
SE
For tabletop use, position the controller for convenient viewing. A swivel
bracket with non-slip rubber feet enables tilting of the controller face to any
viewing angle without the controller sliding when you press the keys.
ONTROLLERS
562 C
AND
ONTROLLERS
60 Series Technical Reference Manual
Installation 2-7
Hide quick links:
Advertisement
Table of Contents
