GSE 60 SERIES Technical Reference Manual page 406

9-158 Chapter 9
GSE Scale Systems
P5003%
Mc 10
4%D%E
The last macro command executed (the last entry in the debug buffer) will
be shown in the rightmost position of the display. From this point, the [? ]
and [ ? ] keys can be used to scroll backwards and forwards through the
debug buffer. Scrolling forward past the end of the buffer will select back
to the beginning.
As you scroll through the debug buffer the display will indicate the macro
number (top right), macro commands (bottom right) and location in the
macro table (last four digits of the parameter number). Contiguously
executed macro commands will appear consecutively in "blocks" of code.
Whenever macro execution is no longer contiguous (i.e. upon completion
of a macro, calling another macro, branching within a macro, etc.), a solid
block character ‡ will appear indicating the separation between
contiguous "blocks".
P5002*
Mc 10
1%O‡L
Since the macro debug table can become quite large, it is often desirable
to skip forward or backward more than one location at a time. You can
skip past "blocks" of macro commands by first keying in the number of
"blocks" to skip before pressing [ ? ] or [ ? ]. For example, keying in
20 [ ? ]
will skip backwards 20 "blocks" from the currently selected point in the
macro debug table. To advance directly to the beginning or end of the
table from any location, press [ . ] before pressing [ ? ] or [ ? ]. This will
ENDofTABLE
take you to the
end of the table, or [ ? ] to access the beginning of the table. You can
also access the last record of the debug buffer by keying in 50001
[SELECT] at any time.
P T M
RINTING HE
The most effective way to analyze the macro debug is to print it. Printing
the macro debug table allows you to transmit the debug in full or partial
detail out any of the four communication ports.
P "F " D
RINTING ULL
To print the macro debug table in full detail, select the desired location in
the table, press [PRINT] and key in the desired comm port number as
prompted. The debug buffer will print from the currently selected location
to the end of the table. To print the entire debug table, advance to the last
record in the table before pressing [PRINT]. The following example
demonstrates how to print the entire debug table.
50001 [SELECT]
prompt. Then press [ ? ] to access the
D T
ACRO EBUG
ETAIL
ABLE