GSE 60 SERIES Technical Reference Manual page 501

The Scale 1 position is not available because the scale input on the main
board is addressed as Scale 1.
I N
NSTALLATION OTES
•
Make sure E1 is configured for the correct scale number selection. If
this is the first multi-scale option card installed (control of scale 2),
then the jumper should be in the 2 position. (GSE default is scale 2).
•
Connect the load cell wiring to J3 of the multi-scale option board.
•
If a 6 lead load cell is used, jumpers E2 and E3 on the multi-scale
module should both be moved to the external (EXT) position.
•
If a 4 lead load cell is used, jumpers E2 and E3 on the multi-scale
module should both be moved to the internal (INT) position.
•
If another option is in use, such as another multi-scale or analog
module, connect it to J2 (NEXT) on the previous module.
•
If any I/O modules are to be installed, they must be daisy chained after
all multi-scale and analog output modules.
•
Route any cables through the rear panel strain reliefs making sure to
connect any shield wires to a grounding stud.
•
Re-assemble the controller and install the rear panel.
M -S S
ULTI CALE
Multi-scale setup parameters beginning at P108 à P142 are used to setup
the multi-scale module. Each scale is selected as an instance, 1 à 8 on
the 660 Series controllers and 1 à 2 on the 460 Series indicators. Refer
to page 3-26 for complete configuration details.
A/D C
ALIBRATION
A printout of the A/D calibration information accompanies each multi-scale
module on a sheet inside the static bag with the circuit board. These
parameters must be entered into the indicator in order for it to read the
scale input accurately. A sample printout appears below:
100%s23640%i%e
61099%s2%e
61101%s 1.000000%e
61102%s 0.000000%e
61103%s 0.000000%e
61104%s8%e
61105%s 60573%e
61106%s2%e
61107%s 1.250029%e
61110%s 64409%e
61111%s -26859%e
61112%s -198972%e
61113%s 0.942661%e
61114%s 0.945947%e
61115%s 0.955080%e
61116%s 0.956094%e
61117%s 808%e
61118%s -1519%e
61119%s -1995%e
61120%s -4857%e
P
ETUP ARAMETERS
P61099. Scale 2
P61101. CAL Factr
P61102. ReZro Wght
P61103. ZrTrk Wght
P61104. CZero
P61105. Fine Zero
P61106. CGain
P61107. Fine Gain
P61110. Zero Adj25
P61111. Zero Adj50
P61112. Zero Ad100
P61113. Gain Adj1
P61114. Gain Adj2
P61115. Gain Adj4
P61116. Gain Adj8
P61117. AIN
P61118. AIN
P61119. AIN
P61120. AIN
60 Series Technical Reference Manual
Options 13-25
1.000000
0.000000
0.000000
0%%
60573
100
1.250029
64409
-26859
-198972
0.942661
0.945947
0.955080
0.956094
NROff 808
NROff -1519
NROff -1995
NROff -4857