GSE 60 SERIES Technical Reference Manual page 77

P143 – P147: Status Name
Assigns the transmitted text of the status parameter (97P) for overload,
underload, motion, stability, underload and error (bad A/D) status at P143
à P147 respectively. Pressing [CLR] without an entry in process will
restore the default status name.
U
NITS
The units parameters are used to assign the default units of measure and
provide custom unit configuration.
P150: Default Units
Selects the scale's default units of measure. All weight-based parameter
values are stored in terms the default units.
P151 – P154: Custom Units
Configures up to two (2) custom units of measure. P151 and P153 are
used to assign the name for custom unit 1 and custom unit 2 respectively.
P152 and P154 are the conversion factors for custom unit 1 and custom
unit 2 respectively. The conversion factor is a conversion from the default
units specified at P150.
T F
ARE UNCTIONS
The tare functions are used to enable the negative tare and tare rounding
features.
P162: Negative Tare
Enables the entry and use of negative tare values.
P163: Tare Rounding
Enables tare rounding. When enabled, the tare value is stored internally
to the display resolution. This is done to ensure that the addition of
multiple tare and net values will yield the correct sum when compared to
the displayed values. When disabled, the tare value is stored to a higher
precision and may result in a discrepancy between the accumulation of
tare and net values as compared to the displayed values.
A O
NALOG UTPUT
The analog output parameters provide configuration of the analog output
modules.
P170: Analog Output Instance
Sets the analog output# in effect when accessing the remainder of the
analog output configuration parameters P171 à P177.
P171: Analog Output Enable
Enables the analog output currently specified at P170.
Setup Parameters 3-27
60 Series Technical Reference Manual