Recording Of Historical Data(Only For Models With Usb Recording); Reset To Factory Settings; Change Ec Signal - GSE 16A Manual

Recording of historical data (Only for model with USB recording):
Depending on the model you have, Recording of historical data is only for controllers with USB
connection.
Go to the menu "Set log file" under the sub menu "Rating" you can choose the Repetition rate e.g:
5minutes. The controller will save all the data's every 5minutes to your USB memory stick. Push
ENTER button the value begins to blink, change the value with the UP / DOWN buttons, save it with
SAVE / EXIT.
General limitations:
All firmware versions support BOMS devices formatted in FAT12, FAT16 or FAT32 file systems only
where the sector size is 512 bytes. No other file systems or sector sizes are allowed.
Format only the USB memory stick on your computer (Windows 7, 8, 10) Plug the USB memory
stick into the USB socket on the controller. If you have set the memory frequency to 5minutes so
every 5minutes once will be written the current measurement data and settings to the USB memory
stick. Make sure when unplugging the USB memory stick from the controller he is not saving the
data's in this moment. Should this happens the file can be damaged or even freeze the controller. A
restart of the controller is required. Plug the power cord for about 20 seconds from the mains.

Reset to factory settings:

Go to the sub menu "Res. factory set" change with UP / DOWN buttons from No? to Yes? Confirm
with ENTER. The controller reset all the data back to the original factory settings except time and
date settings.

Change EC signal

Go to the menu "EC fan signal". Select the output 0-10V analog signal or PWM (pulse wide
modulation) digital signal depending on the EC fan. Read the technical documentation of the EC
fan.
16A Fan controller
EN
29