Repairing The Device - GE MiCOM P40 Agile Technical Manual

Single breaker current differential (with distance)

Hide thumbs Also See for MiCOM P40 Agile:

Table of Contents

Chapter 26 - Maintenance and Troubleshooting

If the top and bottom access covers have been removed, some more screws with

smaller diameter heads are made accessible. Do NOT remove these screws, as they

secure the front panel to the device.

There are four possible types of terminal block: RTD/CLIO input, heavy duty, medium duty, and MiDOS. The terminal blocks are

fastened to the rear panel with slotted or cross-head screws depending on the type of terminal block. Not all terminal block

types are present on all products.

Figure 322: Possible terminal block types

REPAIRING THE DEVICE

If your product should develop a fault while in service, depending on the nature of the fault, the watchdog

contacts will change state and an alarm condition will be flagged. In the case of a fault, either the complete unit or

just the faulty PCB, identified by the in-built diagnostic software, should be replaced.

Replacement of printed circuit boards and other internal components must be undertaken by approved Service

Centres. Failure to obtain the authorization of after-sales engineers prior to commencing work may invalidate the

product warranty.

We recommend that you entrust any repairs to Automation Support teams, which are available world-wide.

REMOVING THE FRONT PANEL

Before removing the front panel to replace a PCB, you must first remove the auxiliary

power supply and wait 5 seconds for the internal capacitors to discharge. You should

also isolate voltage and current transformer connections and trip circuit.

P54x1i-TM-EN-1

Table of Contents

Micom p543i Micom p545i