GE MiCOM P40 Agile Technical Manual page 583

Single breaker current differential (with distance)

Hide thumbs Also See for MiCOM P40 Agile:

Table of Contents

Configure the hardware settings before the device is installed.

Refer to the safety section of the IED.

Switch off the IED. Disconnect the power and all connections.

Before removing the front cover, take precautions to prevent electrostatic discharge damage according to

the ANSI/ESD-20.20 -2007 standard.

Wear a 1 MΩ earth strap and connect it to the earth (ground) point on the back of the IED.

Lift the upper and lower flaps. Remove the six screws securing the front panel and pull the front panel

P54x1i-TM-EN-1

Chapter 22 - Communications

Chapters

Table of Contents

Micom p543i Micom p545i