Handling The Goods - GE MiCOM P40 Agile Technical Manual

Single breaker current differential (with distance)
Hide thumbs Also See for MiCOM P40 Agile:
Table of Contents

Advertisement

Chapter 24 - Installation
2

HANDLING THE GOODS

Our products are of robust construction but require careful treatment before installation on site. This section
discusses the requirements for receiving and unpacking the goods, as well as associated considerations regarding
product care and personal safety.
Caution:
Before lifting or moving the equipment you should be familiar with the Safety
Information chapter of this manual.
2.1
RECEIPT OF THE GOODS
On receipt, ensure the correct product has been delivered. Unpack the product immediately to ensure there has
been no external damage in transit. If the product has been damaged, make a claim to the transport contractor
and notify us promptly.
For products not intended for immediate installation, repack them in their original delivery packaging.
2.2
UNPACKING THE GOODS
When unpacking and installing the product, take care not to damage any of the parts and make sure that
additional components are not accidentally left in the packing or lost. Do not discard any CDROMs or technical
documentation. These should accompany the unit to its destination substation and put in a dedicated place.
The site should be well lit to aid inspection, clean, dry and reasonably free from dust and excessive vibration. This
particularly applies where installation is being carried out at the same time as construction work.
2.3
STORING THE GOODS
If the unit is not installed immediately, store it in a place free from dust and moisture in its original packaging. Keep
any de-humidifier bags included in the packing. The de-humidifier crystals lose their efficiency if the bag is
exposed to ambient conditions. Restore the crystals before replacing it in the carton. Ideally regeneration should
be carried out in a ventilating, circulating oven at about 115°C. Bags should be placed on flat racks and spaced to
allow circulation around them. The time taken for regeneration will depend on the size of the bag. If a ventilating,
circulating oven is not available, when using an ordinary oven, open the door on a regular basis to let out the
steam given off by the regenerating silica gel.
On subsequent unpacking, make sure that any dust on the carton does not fall inside. Avoid storing in locations of
high humidity. In locations of high humidity the packaging may become impregnated with moisture and the de-
humidifier crystals will lose their efficiency.
The device can be stored between –25º to +70ºC for unlimited periods or between -40°C to + 85°C for up to 96
hours (see technical specifications).
2.4
DISMANTLING THE GOODS
If you need to dismantle the device, always observe standard ESD (Electrostatic Discharge) precautions. The
minimum precautions to be followed are as follows:
Use an antistatic wrist band earthed to a suitable earthing point.
Avoid touching the electronic components and PCBs.
622
P543i/P545i
P54x1i-TM-EN-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micom p543iMicom p545i

Table of Contents