Panasonic KX-TDA100 Features Manual page 318

3.2 PC Programming
Parameter
Flash
Flash Detection
Minimum Break Width Specifies the minimum BREAK width.
Flash Width
Line Signal Setting
E & M-P Pulse Length
Seizure
Answer
Clear
E & M-P Seizure ACK
Wink Signal Width
Caller ID
Caller ID Start Code
Caller ID Information
End Code
Caller ID End Code
Port
Parameter
Slot
Port
Connection
Command
Trunk Attribute
Trunk Dialling Mode
Gain Adjustment
DTMF Duration
Trunk Pulse Speed
318 Feature Guide
Description
Assigns the detection of a flash signal.
Specifies the duration time that the system
requires to recognise as a switchhook flash.
Selects the length of the Seizure pulse.
Selects the length of the Answer pulse.
Selects the length of the Clear pulse.
Selects whether the system waits for the E
& M-P Seizure ACK signal.
Specifies the duration time of the Wink
signal.
Selects the start code of Caller ID.
Selects the Caller ID information end code. None/ /#/A/B/C/D
Selects the code of ending Caller ID.
Description
Refers to the slot no. (Display only)
Refers to the port no. (Display only)
Refers to the status of port connection.
(Display only)
Specifies the operating card command.
Selects the trunk attribute.
Selects the trunk dialling mode.
Selects the gain level table during a call.
Selects the duration of the DTMF time.
Selects the pulse speed.
Value Range
Enable/Disable
24 + 8 × n (n=0–60) ms
24 + 8 × n (n=0–188)
ms
150/600 ms
150/600 ms
150/600 ms
Yes/No
128/160/192/224/256/
288 ms
None/ /#/A/B/C/D
None/ /#/A/B/C/D
Value Range
PBX No.–Slot No.
(E & M designates the
number.)
1–8
INS/OUS
INS/OUS
Public/Private
DTMF/Pulse
1–12
80/160 ms
10/20 pps