Panasonic KX-TDA100 Features Manual page 316

3.2 PC Programming
Parameter
Wink Signal Time Out
Start Signal Type
Sending Caller ID to
TIE
Receiving Caller ID
from TIE
Ringback Tone Service Assigns the ringback tone service.
PBX Dial Tone
Answer Waiting Time
Pause Time
Flash Time
Disconnect Time
316 Feature Guide
Description
Specifies the length of time that the system
is to wait for the Wink Signal after seizing
the trunk.
Note
It is assignable only when Start Signal
Type is set to "Wink".
Selects the start signal type.
• Wink: The wink signal is transmitted to
the telephone company before the
incoming calls are received.
• Immediate: No wink signal is
transmitted.
Assigns whether to send TIE Caller ID.
Assigns whether to receive TIE Caller ID.
Assigns whether the system sends a dial
tone to the extension user who seizes a T1
digital trunk line.
Selects the length of waiting time to cancel
the outgoing Trunk call.
Selects the length of Pause Time.
Specifies the length of Flash Time.
Selects the maximum waiting time after
releasing the trunk line before getting it
again.
Value Range
64 × n (n=1–128) ms
Immediate/Wink
Yes/No
Yes/No
Enable/Disable
Enable/Disable
None/1/2/3/4 min
1.5/2.5/3.5/4.5 s
None/16 × n (n=1–80)
ms
0.5/1.5/2.0/4.0/12.0 s