Collect Call Block (Only For Brazil) - Panasonic KX-TDA100 Features Manual

1.1 Incoming Call Features

Collect Call Block (only for Brazil)

Description
A collect call is rejected if the destination is assigned to reject the collect call on a COS basis.
This service is only provided with the following trunk cards:
Type 1: The service works when a collect call is received.
Type 2: The service works when a collect call is answered.
Type
Type 1
Type 2
*: When the trunk card type is the E1 Card, Type 1 or Type 2 depends on the service of the
telephone company.
[Available Destination]
The destinations which can receive collect calls are as follows:
COS programming determines to enable or disable accepting collect calls (disable: Collect
Call Block mode).
Wired Extension (PT/SLT/ISDN
Extension/T1-OPX)
Digital Wireless Extension (DWX)
Incoming Call Distribution Group
DWX Ring Group
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analogue/ISDN Remote Maintenance
Idle Trunk Access no. + Phone no.
Trunk Group Access no. + Phone no.
30 Feature Guide
Trunk Card
Type
E1* A collect call is rejected before it arrives at the destination.
Only assignment on a COS basis for the destination is required.
LCOT A collect call is rejected by sending the Collect Call Blocking (flash)
signal after going off-hook.
E1*
It is required to enable the Collect Call Block mode to each trunk
group first. Assignment on a COS basis for the destination is also
required.
If the telephone company does not support this service, do not
enable the Collect Call Block mode, or normal calls are also
disconnected.
Destination
Description
Receiving
Required COS Assignment
Collect Calls
COS for each extension
COS for each incoming call
distribution group
–
–
–
–
No COS assignment required
– –
– –