Panasonic KX-TDA100 Features Manual page 287

Port
Parameter
Slot
Port
Trunk Connection
Command
Trunk Dialling Mode
Gain Adjustment
CPC Detection
Outgoing
Incoming
DTMF Duration
Pulse Speed
Reverse Detection
Caller ID Detection
Pay Tone Detection
Dial Tone Detection
Pause Time
Flash Time
Disconnect Time
Description
Specifies the slot no. (Display only)
Refers to the port no. (Display only)
Refers to the status of port connection.
(Display only)
Note
To confirm the Trunk connection and
programming using the PT, dial [ ] [3]
[7] + Trunk Access number (3 digits).
You will hear a dial tone if it is available
and connected.
Specifies the operating card command.
Selects the trunk dialling mode.
Selects the gain level applied to the trunk.
Specifies the length of time to detect
outgoing CPC signal.
Specifies the length of time to detect
incoming CPC signal.
Selects the duration of the DTMF signals
sent to the line.
Selects the pulse speed.
Selects when to detect polarity reversal.
Assigns whether to detect the Caller ID.
Assigns whether to detect the pay tone.
Assigns whether to detect the dial tone.
Selects the length of Pause Time.
Specifies the length of Flash Time.
Selects the maximum length of waiting time
after releasing the trunk line before getting
it again.
3.2 PC Programming
Value Range
PBX No.–Slot No.
(LCOT designates the
number).
INS/OUS
INS/OUS
DTMF/Pulse
1–12
None/6.5/8–896 ms
None/6.5/8–896 ms
80/160 ms
Low/High
Disable/Outgoing/
Both Incoming and
Outgoing
Enable/Disable
Enable/Disable
Enable/Disable
1.5/2.5/3.5/4.5 s
None/16 × n (n=1–80)
ms
0.5/1.5/2.0/4.0/12.0 s
Feature Guide 287