Panasonic KX-TDA100 Features Manual page 310

3.2 PC Programming
Parameter
Flash
Flash Detection
Minimum Break Width Specifies the minimum Break Width
Flash Width
Caller ID
Caller ID Start Code
Caller ID Information
End Code
Caller ID End Code
Common–E1 Line Signal Setting
Parameter
Slot
DR2 Signalling Type
Inter-digit Time
Bit Position for Pulse
Dialling
Bit Position for Clear
Back
Forced Release
Forced Release
Pattern
E & M Signalling Type Selects the control bit of the E & M signals.
Wink Signal Width
310 Feature Guide
Description
Assigns the detection of a flash signal
Specifies the duration time that the system
requires to recognise a switchhook flash
after the minimum BREAK width.
Selects the start code of Caller ID.
Selects the Caller ID information code.
Selects the end code of Caller ID.
Description
Specifies the slot no.
Selects the control type of the DR2 (Digital
System R2) signals.
Specifies the pseudo-answer time.
Note
This parameter is available only when
"Option-1" or "Option-3" is selected.
Selects the position of the pulse dialling
control bit in the DR2 Signals.
Selects the position of the Clear Back
Signal Control bit in the DR2 Signals.
Assigns whether to send Forced Release.
Selects the force release bit pattern.
(control bit in the idle condition.)
Specifies the duration time of the Wink
signal.
Value Range
Enable/Disable
24 + 8 × n (n=0–60) ms
24 + 8 × n (n=0–188)
ms
None/ /#/A/B/C/D
None/ /#/A/B/C/D
None/ /#/A/B/C/D
Value Range
PBX No.–Slot No.
(Card type is only E1.)
Normal/Option-1/
Option-2/Option-3
3–15 s
A-bit/B-bit
A-bit/B-bit/A&B-bit
Enable/Disable
A=0:B=0/
A=0:B=1/
A=1:B=0/
A=1:B=1
Type-1: A bit=0/
Type-2: A bit=1/
Type-3: B bit=0/
Type-4: B bit=1/
Type-5: A and B bit=1
128/160/192/224/256/
288 ms