Configuring The Rr To Establish Mp Ibgp Connections With The Client Pes - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number as-number
The RR is specified as the BGP peer.
Step 4 Run:
peer ipv4-address connect-interface interface-type interface-number
The interface is specified as an interface to establish the TCP connection.
The interface IP address must be the same as the MPLS LSR ID. It is recommended to specify
a loopback interface to establish the TCP connection.
Step 5 Run:
ipv4-family vpnv4
The BGP VPNv4 address family view is displayed.
Step 6 Run:
peer
The capability of exchanging VPNv4 routes between the PE and RR is enabled.
----End
3.15.3 Configuring the RR to Establish MP IBGP Connections with
the Client PEs
MP-IBGP connections are configured between the RR and all its clients (PEs) to facilitate
VPNv4 route reflection.
Context
Choose one of the following schemes to configure the RR.
Procedure
l
Issue 01 (2012-04-20)
ipv4-address enable
Configuring the RR to Establish MP IBGP Connections with the Peer Group
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
group group-name [ internal ]
An IBGP peer group is created.
4. Run:
peer group-name connect-interface interface-type interface-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP MPLS IP VPN Configuration
137