Power Connection Diagram (Frame E); Power Connection Diagram (Frame F) - Parker 650G Product Manual

3-17
Installing the Drive

Power Connection Diagram (Frame E)

if not fitted inside a control cubicle
All screens terminated using a gland at the gland plate
Note: The standard Frame E terminals are not intended for flat busbar. A Power Terminal
adaptor is available to enable wiring with flat busbar, part number BE465483.
1. Remove the terminal cover retaining screws and lift off the terminal cover.
2. Feed the power supply and motor cables into the drive through the metal gland plate using

Power Connection Diagram (Frame F)

auxiliary
Note: The standard Frame F terminals are not intended for flat busbar. A Power Terminal
adaptor is available to enable wiring with flat busbar, part number BE465483.
1. Remove the terminal cover retaining screws and lift off the terminal cover.
2. Feed the power supply and motor cables into the drive through the metal gland plate using
IMPORTANT: Remember to provide the auxiliary supply for the Frame F cooling fan. In Chapter 9,
check for the correct voltage via the Product Code, and refer to Cooling Fans for correct
wiring.
L1 L2
PE1
PE L1
3PH L2
Brake resistor and cable must be screened
the correct cable entries, and connect to the power terminals. Tighten all terminals to the
correct tightening torque, refer to the Terminal Tightening Torques table.
L1 L2
supply
(fan)
PE1
PE L1
3PH L2
All screens terminated using a gland at the gland plate
the correct cable entries, and connect to the power terminals. Tighten all terminals to the
correct tightening torque, refer to the Terminal Tightening Torques table.
www.comoso.com
L3 DC+ DC- M1/U M2/V
L3
M
L3 DC+ DC- M1/U M2/V
L3
M
M3/W DBR+ DBR-
brake
resistor
M3/W
DBR+ DBR-
brake MOT/
TEMP
resistor
motor thermistor
(on control board
support bracket)
650G AC Drive
MOT/
TEMP
motor
thermistor